Skip to content
RigMyFishFind a Rig

How to Tie a Homer Rhode Loop Knot

intermediate · Make a loop

MonofilamentFluorocarbon

Giving a lure a fixed loop in heavier leader

Make a loop connection-category illustration, not a knot-tying diagram
Make a loop · Connection type illustration

This guide uses the improved two-turn finish to the Homer Rhode loop.

Before you tie: Heavy leader can require tools to seat fully; control the lure points.
Start tying: 5 steps ↓

Tie it step by step

The standing line is the long section leading to your rod. The tag end is the short free end you work with.

0 of 5 steps practiced. Check off each step as you learn.

  1. Step 1

    Tie an overhand knot near the tag, then thread the lure eye.

  2. Step 2

    Return through the overhand loop on the same side the tag left it. Close that first knot near the eye.

  3. Step 3

    Use the tag to make two neighboring turns around the standing line.

  4. Step 4

    Return the tag through these turns and snug this second knot where the desired loop size is set.

  5. Step 5

    Moisten and draw the standing line until the two knots meet. Seat, check, and trim.

Follow the line path

Use this original summary alongside the linked visual reference, especially for the crossings and hand placement. Cover artwork is not a tying diagram.

Open the visual tying reference ↗ (new tab)

Reference: NetKnots · Guide checked 2026-11-07

Common Mistakes

  • •Seating the second knot at the wrong distance
  • •Expecting a partly seated heavy-line knot to hold
Set the loop size before the two knots lock together.

Compare other connections

Browse the full knot library →

Common Questions

When should I use the Homer Rhode Loop Knot?

This guide uses the improved two-turn finish to the Homer Rhode loop.

What is the most common mistake tying the Homer Rhode Loop Knot?

Seating the second knot at the wrong distance

Any tips for a stronger Homer Rhode Loop Knot?

Set the loop size before the two knots lock together.