Skip to content
RigMyFishFind a Rig

How to Tie a Willis Knot

intermediate · Join two lines

MonofilamentLead-core line

Connecting a mono leader inside lead-core line’s sheath

Join two lines connection-category illustration, not a knot-tying diagram
Join two lines · Connection type illustration

A specialist trolling connection that uses the hollow outer sheath after removing some core.

Before you tie: For compatible lead-core constructions; this guide uses a mono leader.
Start tying: 4 steps ↓

Tie it step by step

The standing line is the long section leading to your rod. The tag end is the short free end you work with.

0 of 4 steps practiced. Check off each step as you learn.

  1. Step 1

    Slide back four to six inches of outer sheath and remove that length of inner lead core.

  2. Step 2

    Straighten the empty sheath and make a loose overhand in it near the remaining core.

  3. Step 3

    Insert the mono leader into the hollow sheath until it meets the core.

  4. Step 4

    Work the overhand toward the sheath end, keeping the leader inside. Tighten and pull-check the grip.

Follow the line path

Use this original summary alongside the linked visual reference, especially for the crossings and hand placement. Cover artwork is not a tying diagram.

Open the visual tying reference ↗ (new tab)

Reference: NetKnots · Guide checked 2026-11-07

Common Mistakes

  • •Leaving too little leader inside the sheath
  • •Damaging the sheath while cutting the core
Inspect the sheath for damage before inserting the leader.

Compare other connections

Browse the full knot library →

Common Questions

When should I use the Willis Knot?

A specialist trolling connection that uses the hollow outer sheath after removing some core.

What is the most common mistake tying the Willis Knot?

Leaving too little leader inside the sheath

Any tips for a stronger Willis Knot?

Inspect the sheath for damage before inserting the leader.