Skip to content
RigMyFishFind a Rig

How to Tie a Albright Knot

intermediate · Join two lines

MonofilamentFluorocarbonBraid / superlineFly line / backing

Connecting lines with different diameters or materials

Join two lines connection-category illustration, not a knot-tying diagram
Join two lines · Connection type illustration

Useful when the thicker material can form a loop and the thinner material can wrap around it.

Also called: Albright Special

Before you tie: Large diameter differences need careful seating and a firm pull check.
Start tying: 4 steps ↓

Tie it step by step

The standing line is the long section leading to your rod. The tag end is the short free end you work with.

0 of 4 steps practiced. Check off each step as you learn.

  1. Step 1

    Bend the heavier line into a loop and insert a generous length of the thinner line.

  2. Step 2

    Hold the three sections together. Wind the thin tag ten times around its own standing section and both heavy strands.

  3. Step 3

    Put the thin tag back through the heavy loop, leaving on the same side it entered.

  4. Step 4

    Wet the connection, slide the coil toward the fold, and tension the thin line while controlling both heavy ends. Check and trim.

Follow the line path

Use this original summary alongside the linked visual reference, especially for the crossings and hand placement. Cover artwork is not a tying diagram.

Open the visual tying reference ↗ (new tab)

Reference: NetKnots · Guide checked 2026-11-07

Common Mistakes

  • •Crossing turns as they are wound
  • •Sending the tag out the opposite side of the heavy loop
Keep each turn adjacent to the last.

Compare other connections

Browse the full knot library →

Common Questions

When should I use the Albright Knot?

Useful when the thicker material can form a loop and the thinner material can wrap around it.

What is the most common mistake tying the Albright Knot?

Crossing turns as they are wound

Any tips for a stronger Albright Knot?

Keep each turn adjacent to the last.