How to Tie a Seaguar Knot
intermediate · Join two lines
Connecting a fluorocarbon leader to monofilament
A joining option made by twisting two aligned loops together.
Tie it step by step
The standing line is the long section leading to your rod. The tag end is the short free end you work with.
0 of 4 steps practiced. Check off each step as you learn.
Step 1
Make a loop in each line and align the two loops side by side.
Step 2
Insert a finger through both and turn them together three full times.
Step 3
Keep the opening clear and feed the short main-line tag and the entire leader through it.
Step 4
Moisten and draw all four sections into the figure-eight-shaped join. Alternate tension to seat, then trim.
Follow the line path
Use this original summary alongside the linked visual reference, especially for the crossings and hand placement. Cover artwork is not a tying diagram.
Open the visual tying reference ↗ (new tab)Reference: NetKnots · Guide checked 2026-11-07
Common Mistakes
- •Twisting only one loop
- •Leaving one section slack while the join closes
Compare other connections
Double Uni Knot →
Joining your main line to a leader with two Uni knots pulled together
Alberto Knot →
Joining braided main line to a thicker mono or fluorocarbon leader
Albright Knot →
Connecting lines with different diameters or materials
Common Questions
When should I use the Seaguar Knot?
A joining option made by twisting two aligned loops together.
What is the most common mistake tying the Seaguar Knot?
Twisting only one loop
Any tips for a stronger Seaguar Knot?
Lay out the leader before feeding it through the shared opening.