Skip to content
RigMyFishFind a Rig

How to Tie a Orvis Tippet Knot

intermediate · Join two lines

MonofilamentFluorocarbon

Adding tippet to a fly leader

Join two lines connection-category illustration, not a knot-tying diagram
Join two lines · Connection type illustration

A compact joining option that uses both working sections through a loop.

Before you tie: Long tippets require more room to feed through the knot.
Start tying: 5 steps ↓

Tie it step by step

The standing line is the long section leading to your rod. The tag end is the short free end you work with.

0 of 5 steps practiced. Check off each step as you learn.

  1. Step 1

    Overlap the leader and tippet by several inches.

  2. Step 2

    Fold the overlapping pair back over itself to make a loop and pinch the crossing.

  3. Step 3

    Take the working ends behind the paired standing sections and upward.

  4. Step 4

    Pass the leader tag and the full tippet through the held loop twice.

  5. Step 5

    Wet and draw all four sections evenly to close the join. Check before trimming.

Follow the line path

Use this original summary alongside the linked visual reference, especially for the crossings and hand placement. Cover artwork is not a tying diagram.

Open the visual tying reference ↗ (new tab)

Reference: NetKnots · Guide checked 2026-11-07

Common Mistakes

  • •Passing only the short tag instead of the entire tippet
  • •Pulling on just two sections while dressing
Keep the complete tippet length free to pass through.

Compare other connections

Browse the full knot library →

Common Questions

When should I use the Orvis Tippet Knot?

A compact joining option that uses both working sections through a loop.

What is the most common mistake tying the Orvis Tippet Knot?

Passing only the short tag instead of the entire tippet

Any tips for a stronger Orvis Tippet Knot?

Keep the complete tippet length free to pass through.