Skip to content
RigMyFishFind a Rig

How to Tie a Needle Knot

advanced · Join two lines

MonofilamentFly line / backing

Routing a leader through a fly-line tip before securing it

Join two lines connection-category illustration, not a knot-tying diagram
Join two lines · Connection type illustration

A specialist fly-line connection that modifies the tip of a compatible line.

Before you tie: This permanently alters the fly-line tip and requires care with a sharp needle.
Start tying: 5 steps ↓

Tie it step by step

The standing line is the long section leading to your rod. The tag end is the short free end you work with.

0 of 5 steps practiced. Check off each step as you learn.

  1. Step 1

    Use a suitable needle to open a short channel from the fly-line end and out through its side.

  2. Step 2

    Withdraw the needle and feed the fine end of the leader through the side opening and out the tip.

  3. Step 3

    Pull the leader through until enough butt remains outside to tie the fastening coil.

  4. Step 4

    Using a smaller needle or tube as a guide, make five leader wraps around the fly line and itself.

  5. Step 5

    Return the leader tag beneath the wraps, remove the guide, and seat the coil by the exit hole. Inspect and trim.

Follow the line path

Use this original summary alongside the linked visual reference, especially for the crossings and hand placement. Cover artwork is not a tying diagram.

Open the visual tying reference ↗ (new tab)

Reference: NetKnots · Guide checked 2026-11-07

Common Mistakes

  • •Damaging the core with an oversized needle
  • •Attempting the connection on an unsuitable fly line
Confirm that your fly-line maker permits a pierced-tip connection.

Compare other connections

Browse the full knot library →

Common Questions

When should I use the Needle Knot?

A specialist fly-line connection that modifies the tip of a compatible line.

What is the most common mistake tying the Needle Knot?

Damaging the core with an oversized needle

Any tips for a stronger Needle Knot?

Confirm that your fly-line maker permits a pierced-tip connection.