Skip to content
RigMyFishFind a Rig

How to Tie a Nail Knot

intermediate · Join two lines

MonofilamentFly line / backing

Attaching a leader butt or backing to fly line

Join two lines connection-category illustration, not a knot-tying diagram
Join two lines · Connection type illustration

Useful when you want a wrapped attachment instead of a loop-to-loop join.

Before you tie: Not every coated fly line tolerates the same grip; follow the line maker’s connection advice.
Start tying: 5 steps ↓

Tie it step by step

The standing line is the long section leading to your rod. The tag end is the short free end you work with.

0 of 5 steps practiced. Check off each step as you learn.

  1. Step 1

    Place a small hollow tube alongside the fly-line tip and leader butt. Leave a generous leader tag.

  2. Step 2

    Wind the leader tag six to eight times around itself, the fly line, and the tube.

  3. Step 3

    Send the tag back through the tube beneath the wraps.

  4. Step 4

    Hold the coil while withdrawing the tube. Moisten, snug the tag, then pull the leader to seat the coil.

  5. Step 5

    Check the grip before cutting the excess line.

Follow the line path

Use this original summary alongside the linked visual reference, especially for the crossings and hand placement. Cover artwork is not a tying diagram.

Open the visual tying reference ↗ (new tab)

Reference: NetKnots · Guide checked 2026-11-07

Common Mistakes

  • •Removing the tube before threading the tag
  • •Leaving gaps in the coil
A purpose-made knot tool can substitute for the tube.

Compare other connections

Browse the full knot library →

Common Questions

When should I use the Nail Knot?

Useful when you want a wrapped attachment instead of a loop-to-loop join.

What is the most common mistake tying the Nail Knot?

Removing the tube before threading the tag

Any tips for a stronger Nail Knot?

A purpose-made knot tool can substitute for the tube.