How to Tie a Haywire Twist
intermediate · Specialist connections
Attaching single-strand wire leader to a hook or swivel
For suitable single-strand wire rather than ordinary nylon or coated multi-strand cable.
Tie it step by step
The standing line is the long section leading to your rod. The tag end is the short free end you work with.
0 of 5 steps practiced. Check off each step as you learn.
Step 1
Thread the wire through the eye and fold back a working tag.
Step 2
Hold both sections at a broad angle and twist them around each other for at least three and a half haywire turns.
Step 3
Bend the tag across the standing wire at a right angle.
Step 4
Make about five close barrel wraps with the tag around the standing wire.
Step 5
Bend a handle in the waste tag and rock it until it breaks at the final wrap, avoiding a sharp clipped burr.
Follow the line path
Use this original summary alongside the linked visual reference, especially for the crossings and hand placement. Cover artwork is not a tying diagram.
Open the visual tying reference ↗ (new tab)Reference: NetKnots · Guide checked 2026-11-07
Common Mistakes
- •Making only barrel wraps from the start
- •Leaving a sharp wire burr
Compare other connections
Bobber Stopper Knot →
Setting the depth above a sliding float
Yarn Indicator Loop →
Holding a small yarn strike indicator on a fly leader
Riffle Hitch →
Making a fly skate across the water surface
Explore a complete rig next
See the components and choose a connection that suits your line and tackle.
Common Questions
When should I use the Haywire Twist?
For suitable single-strand wire rather than ordinary nylon or coated multi-strand cable.
What is the most common mistake tying the Haywire Twist?
Making only barrel wraps from the start
Any tips for a stronger Haywire Twist?
Distinguish the first mutual twists from the later one-around-one barrel wraps.