How to Tie a Bobber Stopper Knot
beginner · Specialist connections
Setting the depth above a sliding float
Tie a separate stopper onto the main line so a slip float stops at the chosen depth.
Also called: Slip Float Stop Knot
Tie it step by step
The standing line is the long section leading to your rod. The tag end is the short free end you work with.
0 of 4 steps practiced. Check off each step as you learn.
Step 1
Lay a short piece of suitable stopper line beside the main line.
Step 2
Double the stopper back to make a loop; pinch its crossing against the main line.
Step 3
Wind the stopper tag through that loop and around both sections two or three times.
Step 4
Wet and pull the stopper ends apart until it grips. Check that it slides deliberately but stops the float.
Follow the line path
Use this original summary alongside the linked visual reference, especially for the crossings and hand placement. Cover artwork is not a tying diagram.
Open the visual tying reference ↗ (new tab)Reference: NetKnots · Guide checked 2026-11-07
Common Mistakes
- •Accidentally tying the main line into the stopper
- •Trimming tags so short the stopper cannot be adjusted
Compare other connections
Yarn Indicator Loop →
Holding a small yarn strike indicator on a fly leader
Riffle Hitch →
Making a fly skate across the water surface
Tenkara Level-Line Connection →
Attaching a level line to a tenkara rod’s lilian
Explore a complete rig next
See the components and choose a connection that suits your line and tackle.
Common Questions
When should I use the Bobber Stopper Knot?
Tie a separate stopper onto the main line so a slip float stops at the chosen depth.
What is the most common mistake tying the Bobber Stopper Knot?
Accidentally tying the main line into the stopper
Any tips for a stronger Bobber Stopper Knot?
Leave enough stopper tag to adjust its tension later.